Programming The Gsmvlp-Adt Module; Using The Alarmnet Direct Website - ADT GSMVLP- Installation And Programming Manual

WIRE
ROUTING
TUNNELS
TIE-WRAP
POINT
MOUNTING
HOOK
AUDIO
CABLE
Figure 4 – GSMVLP-ADT Wiring Connections and Routing

Programming the GSMVLP-ADT Module

The GSMVLP-ADT Module can be programmed through the following methods:
•
The AlarmNet Direct website
•
Use of a 7720P Programming Tool

Using the AlarmNet Direct website

To program the module via the website (if you are already signed up for this service), go to:
https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx
If you are not signed up for this service, click on "Dealer Sign-Up". Log in and follow the on-screen
prompts. Please have the following information available when programming the module:
1. CS1 IP Address (12-digit number)
2. CS1 Port (0-65535)
3. Access Point Name (APN 1) (roch, aurora, kc)
4. CS2 IP Address (12-digit number)
5. CS2 Port (0-65535)
6. Access Point Name (APN 2) (roch, aurora, kc)
7. Primary Subsystem Number (two-digit number)
8. Primary Group Number (three-digit number)
9. Primary Subscriber ID (four-digit number)
10. After programming is complete, you must transfer the data to the GSMVLP-ADT.
BATTERY
CABLE
ECP/POWER
CABLE
FRONT
CASE
– 6 –
BACK
CASE
7720P
PROGRAMMING
JACK
TIE WRAP
MOUNT
MOUNTING
HOOK
TIE WRAP
GSMVLP-001-V0