HUEDA™-Multi Zone LED Controller
HUEDA™-Multi Zone LED Color Controller
System Wiring Diagram
The following wiring diagram is as an example system connectivity. CAT5 (RJ45 connections) cables are the most
effective solution for transmitting DMX-512 signals. XLR-3 cables may also be installed but require an additional
adapter for connecting to DMX decoders (LT-840). With DMX decoders like LT-840, it is possible to transmit signal
wireless with use of LC-512X wireless sticks. Always review each component's installation guide for detailed and up-
to-date wiring instructions. Install in accordance with NEC and local regulations.
Method 1 :
Class 2 Low Voltage Driver *
Max 500mA
L
L
N
N
G
AC Power
50/60Hz
Class 2 Low Voltage Driver *
L
V+
N
V-
G
AC Power
50/60Hz
Class 2 Low Voltage Driver *
L
V+
N
V-
G
AC Power
50/60Hz
RJ45 / XLR-3
Adapter Connector
* Use a compatible Class 2 constant voltage driver. It is recommended to load the driver no more than 80%.
For additional information and questions please contact our technical support.
5/7
Copyright © 2015 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
Power In
DMX Data Out
VDC
VDC
_
+
GND
Vin
D-
D+
GND
V+
V-
DMX Decoder (LT-840)
Data IN
DC+ DC-
Data OUT
DMX Decoder (LT-840)
Data IN
Data OUT
DC+ DC-
AC Power
50/60Hz
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.4 10/19/15
HUEDA™ Controller
SR-2811DMX(US)
GND
Vin
D-
D+
GND
Power
Input
R
G
B
Ch1 Ch2 Ch3 Ch4
V+
R
G
B
Ch1 Ch2 Ch3 Ch4
V+
Wall Washer / DMX-512 Fixture
INSTALLATION SHEET
INSTALLATION SHEET
Warning
wrong
+ -
Make sure that
wires cannot
cross
RJ45 Splice Cable
Wiring Connections
DMX Data
White/Orange
Output
Orange
Brown
Ground
Channel Color
Channel 1 - Red
Channel 2 - Green
Channel 3 - Blue
Channel 4 - White (optional)
RGB Strip Light / Fixture
RGB Strip Light / Fixture
CH4-W connection: only utilized for white LED strip.
correct
+ -
Make sure that
wires are screwed tight
and fully inserted
Data +
Data -