Wiring Connections; Setting The Dmx Address - LED World HUEDA Installation Sheet

HUEDA™-Multi Zone LED Controller HUEDA™-Multi Zone LED Color Controller

Wiring Connections

DO NOT connect directly to 120VAC.
See 'System Diagram for a general system design.
Reset
Switch
GND
From 12-24V
To DMX Decoder
or DMX xture
WARNING!!!
Never install the HUEDA™ Controller in with other high voltage Junction Box as there is a risk of shock
hazzard! National Electric Code requires electrical conductors to be separated by a barrier within the box or in a
separate box!. Install only in the provide Junction box

Setting the DMX Address

Each DMX decoder or DMX xture need to be addressed correctly so the controller can distinguish between
each one. To pair a DMX decoder or xture to a specic zone of the controller (1-3), set each decoder/xture
to one of the following addresses
Zone 1: Set to address '001' (will be xed to address 001 – 004)
1 2 3 4 5 6 7 8 9 10
DIP
Zone 2: Set to address '005' (will be xed to address 005 – 008)
1 2 3 4 5 6 7 8 9 10
DIP
Zone 3: Set to address '009' (will be xed to address 009 – 012)
1 2 3 4 5 6 7 8 9 10
DIP
3/7
Copyright © 2015 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
Data + Data -
Vin GND
OFF
ON
ON
OFF
ON
ON
OFF
ON
ON
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.4 10/19/15
Mounting
Install with the included DMX controller wall box.
Pop off faceplate with a athead screwdriver
Each zone of the controller is xed with 4 DMX
addresses to control the 4 channels:
Ch1 – Red, CH2 – Green, CH3 – Blue, CH4 – White or X
INSTALLATION SHEET
INSTALLATION SHEET