Siemens SIMATIC IFP2200 Product Information page 26

The table below provides information on the type and scope of tests for mechanical ambient conditions.
Tested for
Vibrations
Shock
Reducing vibration and shock
If the device is subjected to heavy shocks or vibrations, you must take appropriate measures to reduce acceleration or
amplitude during installation.
Climatic ambient conditions
The following table shows the climatic ambient conditions for operation of the device.
Ambient conditions
Temperature, vertical mounting:
Temperature, inclined mounting
Relative humidity
Atmospheric pressure
Pollutant concentration
see section Permitted mounting positions (Page 17)
1
Note
Internal temperature of the housing or control cabinet
When the device is mounted, the internal temperature of the housing or control cabinet must not exceed 55 °C.
Information on insulation tests, protection class and degree of protection
Test voltages
Insulation strength is demonstrated in the type test with the following test voltages in accordance with IEC 61131-2:
Circuits with a nominal voltage of U
24 V
Protection class
Protection class I in accordance with IEC 61140, i.e. a protective conductor connection to the device is required.
Information on the position of the protective conductor connection is available in the section "Connecting the device (Page 19)".
26
Test standard
Vibration test in accordance with
IEC 60068, Part 2-6 (sine)
Vibration duration: Ten frequency
cycles per axis in each of the three
mutually vertical axes
Type of vibration: Frequency cycles
at a rate of change of 1
octave/minute.
Shock test in accordance with
IEC 60068, Part 2-27
Permitted range
0 ... 45 °C (landscape format)
0 ... 40 °C (portrait format)
0 ... 40 °C (landscape format)
1
0 ... 35 °C (portrait format)
10% to 90%, without condensation
1140 to 795 hPa
SO
Relative humidity < 60 %, no
condensation
H
Relative humidity < 60 %, no
condensation
to other circuits or ground
e
Comments
Mechanical class 2:
10 Hz ≤ f ≤ 58 Hz, constant amplitude 0.0375 mm
58 Hz ≤ f ≤ 200 Hz, constant acceleration 4.9 m/s
Mechanical class 3:
5 Hz ≤ f ≤ 8.4 Hz, constant amplitude 3.5 mm
8.4 Hz ≤ f ≤ 200 Hz, constant acceleration 9.8 m/s
Type of shock: Half-sine
Severity of shock: Peak value 15 g, duration 11 ms
Direction of shock: 3 shocks in ± direction of axis in each of
the three axes vertical to each other
: < 0.5 vpm;
2
S: < 0.1 vpm;
2
Test voltage
707 V DC or 500 V AC
Comments
Inclination: Maximum 35°
Corresponds to an elevation
of -1000 to 2000 m
Test: 10 cm /m ; 21 days
3 3
Test: 1 cm /m ; 21 days
3 3
SIMATIC IFP2200/2400 ITC2200/2400 frameless
A5E48015893-AB, 10/2020
2
2