Description (Fig. 1) - DeWalt DW089K-XJ Manual

E NGLIS H
A flashing red indicator light indicates that the batteries are low and
need to be replaced. The laser may continue to operate for a short time
while the batteries continue to drain, but the beam(s) will quickly dim.
After fresh batteries are installed and the laser is turned on again, the
laser beam(s) will return to full brightness and the red indicator light will
stay off. (A flashing laser beam is not caused by low batteries; see Out
of Tilt Range Indicator.)

Description (fig. 1)

a. Battery compartment cover
b. Red indicator light
c. ON/OFF button, horizontal laser line
d. ON/OFF button, vertical laser line
e. ON/OFF button, side vertical laser line
f. Magnetic pivot bracket
g. Keyhole slot
h. Fine adjustment knob
i. 1/4" x 20 female thread
INTENDED USE
The 3 Beam laser DW089K-XJ/DW089CG-XJ has been designed to
project laser lines to aid in professional applications. The tool can be
used for horizontal (level), vertical (plumb) and square alignment. The
applications range from layout of walls and windows to installation of
framing track.
DO NOT use under wet conditions or in presence of flammable liquids
or gases.
The 3 Beam laser is a professional tool. DO NOT let children come
into contact with the tool. Supervision is required when inexperienced
operators use this tool.
60
DW089K-XJ_DW89CG-XJ User Manual - EU - FEB 2019 - Part A.indd 60
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
2/7/2019 10:35:52 AM