Table of Contents
Advertisement
Remove/Install a Flex-Bay Device - Power On
You can use the Softex Bay Manager utility to hot-swap your devices in the flex-bay.
To start the Softex Bay Manager utility:
1. Click Start > Control Panel > Other Control Panel Options > Softex Bay
Manager.
- or -
2. Double-Click the SwapBay icon
To remove a device:
1. Start the Softex Bay Manager Utility.
You do not have to turn the computer over or tip it on its side to change
devices. Simply tilt the computer up at the front about 10 cm and locate the
Flex-Bay latch. See Figure below for the location of the Flex-Bay latch. The
computer in the figure is tilted on its side for clarity.
2.
Click Remove / Swap. A Device Change popup window stating, "Please wait until
the system processes the device change" appears then another popup window
appears and says, "Please remove or swap your bay device(s) now and press OK."
3. Tilt the computer up & locate the smart bay latch.
4. Slide and hold the device latch toward the front of the computer.
5. Slide the device out.
6. Click OK. The message "Please wait until the system processes the device change"
appears again.
7. Click OK to close the Softex Bay Manager Utility.
28 Users Manual
Flex-Bay Latch
in the windows taskbar.
Advertisement
Table of Contents
