Auto-Off Option; Hints And Tips; The Laundry Load - Zanussi ZWT 3207 User Manual

• Keep the lid ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The indicator flashes to remind you to drain
the water.
• The lid lock indicator
button flashes. The lid stays locked.
• You must drain the water to open the lid.
Draining the water:
1. To drain the water.
• Touch the button
the water and spins with the maximum spin
speed for selected washing programme.
• Alternatively, touch the button
the spin speed and then touch the button
. The appliance drains the water and
spins. If you set
drains.
2. When the programme is completed and after a
couple of minutes the lid lock indicator
goes off, you can open the lid.

HINTS AND TIPS

THE LAUNDRY LOAD

• Divide the laundry in: white, coloured,
synthetics, delicates and wool.
• Obey the washing instructions that are on the
laundry care labels.
• Do not wash white and coloured items together.
• Some coloured items can discolour with the first
wash. We recommend that you wash them
separately for the first times.
• Turn multilayered fabrics, wool and items with
painted illustrations inside out.
• Wash and pre-treat heavy soil stains with a
suitable detergent before putting in drum.
• Be careful with the curtains. Remove the hooks
and put the curtains in a washing bag or
pillowcase.
• Do not wash laundry without hems or with cuts.
Use a washing bag to wash small and/or
delicate items (e.g. underwired bras, belts,
tights, shoelaces, ribbons, etc. ).
16
is on. The indicator of
. The appliance drains
to change
, the appliance only
3. Press the button
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).

AUTO-OFF OPTION

The AUTO-OFF stand-by option automatically
deactivates the appliance to decrease the energy
consumption. All the indicators and the display go
off when :
• You do not use the appliance for 5 minutes
before you touch
Press the button
again.
• After 5 minutes from the end of the washing
programme.
Press the button
again.
The display shows the end of the last set
programme.
Touch the button
cycle.
• A very small load can cause balance problems
with the spin phase leading to excessive
vibration. If this occurs:
- interrupt the programme and open the door
(refer to "Daily Use" chapter);
-manually redistribute the load so that the items
are spaced evenly around the tub;
-press the button. The spin phase
continues.
• Avoid washing garments full of long animal hair
or poor quality garments releasing lots of fluff
that could block the drain circuit and therefore
requiring the Service assistance.
• Button up pillowcases, close zippers, hooks and
poppers. Tie up belts, cords, shoelaces, ribbons
and any other loose elements.
for some seconds to
.
to activate the appliance
to activate the appliance
if you want to set a new