Download Print this page

Calsense ET1 Setup Manual

Rain bucket setup

Hide thumbs Also See for ET1:

Download this manual

RAIN BUCKET SETUP

RAIN BUCKET

ET1 RAIN BUCKET SETUP

water work

m aking

since 1986

Need help?

Do you have a question about the ET1 and is the answer not in the manual?

Page 1 RAIN BUCKET SETUP ® RAIN BUCKET ET1 RAIN BUCKET SETUP water work m aking since 1986...
Page 2: Rain Bucket
RAIN BUCKET SETUP ® RAIN BUCKET ET 1 RAIN BUCKET SET-UP ET1 SETUP KEY SEQUENCE: After the Calsense ET1 SET-UP CHANGE KEY SEQUENCE: All Rain Bucket is installed, it must be enabled in the Changes in Set-up are made using the following Controller Set-up program.
Page 3 This section describes the steps necessary to set-up the controller to use rain. To use this feature, the controller must be connected to a Rain Bucket, or have the ability to share rain data through the Calsense Command Center software.
Page 4 Each of the seven (7) Programs in the ET1 have independent hold-over time settings. The default setting is “YES”. You can change the setting to “NO”...
Page 5: Rain Switch
RAIN BUCKET SETUP ® Press the button to move to the next entry. CHANGE Press the button to move to the next screen. ENTER RAIN SWITCH (Rain Guard, Mini-Clik, etc) Controller has a RAIN SWITCH : NO Figure 3 Rain Switch: If a Rain Switch, Mini-Clik, or other Rain device other than a rain bucket is connected to the controller select YES, if not the default setting is NO.
Page 6 RAIN BUCKET SETUP ® ® 2075 Corte del Nogal, Suite P, Carlsbad CA 92011 1-(800)-572-8608 FAX: 1-(760)-438-2619 www.calsense.com Stock Number: PG1-RB-D1 Rev. 03/06 water work m aking since 1986...