Samsung AS18A9RCF Service Manual page 7

Ι Ι
Disassemble and reassemble (cont'd)
No.
Part
3
Electrical
Parts
(Main PCB)
4
Heat
Exchanger
6
Procedure
1) Take out all the connector of PCB
on the upper part.
2) Separate the outdoor unit connection wire
from the terminal block.
3) If you pull out the main PCB up, it will be
taken out.
1) Loosen two ground screws at the right
side.
2) Separate the connection pipe.
3) Separate the bush body at the upper
side and holder at the rear side.
4) Loosen the two screws at the left side.
5) Lift the heat exchanger up a little to push
the upper side to separate it from the
indoor unit.
Remark