Table of Contents
Advertisement
8. SPEED SELECTION
Recommended Speed Settings
The
figures
listed
are
intended as a guide only.
Always test settings and
accessories on a scrap piece
of material beforehand.
TROUBLESHOOTING
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents. This is
normal and does not indicate a problem.
The tool loses power during use.
•
Battery could be low and requires charging.
•
The tool could have overloaded due to excessive pressure. Turn
the product back on and reduce the load.
LED Light Collar does not turn on
•
Battery could be low and require replacing. Undo the 3 screws on the back of the
LED collar and replace the 2 CR927 batteries. Take note of the direction of the button
cell batteries when replacing them.
MAINTENANCE
Cleaning
• We recommend that you clean the appliance immediately after you use it.
• Keep the safety devices free of dirt and dust as much as possible. Wipe the equipment with a
clean cloth.
• Clean the appliance regularly with a damp cloth and some soft soap. Do not use cleaning
agents or solvents; these may be aggressive to the plastic parts in the appliance. Ensure that no
water can get into the interior of the appliance.
Storage
Keep in a dry, frost free location, out of reach of children.
Note: Eurotops Versand GmbH will not be responsible for any damage or injuries
caused by the repair of the tool by an unauthorised person or by mishandling of the
tool.
ELECTRICAL SAFETY
WARNING!
When using mains-powered tools, basic safety precautions, including the
following, should always be followed to reduce risk of fire, electric shock, personal injury and
material damage. Read the whole manual carefully and make sure you know how to switch the
tool off in an emergency, before operating the tool. Save these instructions and other documents
supplied with this tool for future reference.
This tools charger is double insulated; therefore no earth wire is required.
Note: Double insulation does not take the place of normal safety precautions when operating
this tool. The insulation system is for added protection against injury resulting
from a possible electrical insulation failure within the tool. If the supply cord is
damaged, it must be replaced by an electrician or a power tool repairer in order to
avoid a hazard.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool. Before use,
inspect the extension lead for signs of damage, wear and ageing. Replace the extension lead if
damaged or defective. When using an extension lead on a reel, always unwind the lead
completely. Use of an extension lead not suitable for the power input of the tool or which is
damaged or defective may result in a risk of fire andelectric shock. The power supply for this
products charger should be protected by a residual current device (rated at 30mA or less). A
residual current device reduces the risk of electric shock.
Advertisement
Table of Contents
