Advertisement
Assembly
Note: For parts identification, refer to parts list.
1. Insert upper handle (36) into lower handle (35) and fasten with hex cap bolt (37).
2. Remove handle bolt (33) and spacer (34).
3. Insert handle assembly into handle socket (38). Make sure handle assembly engages gear
shaft (27) by turning handle back and forth and observing movement of handle socket gear
(30).
4. Install handle bolt (33) and spacer (34) to secure handle assembly.
Lubrication
Note: Before initial operation, lubricate the jack as indicated in Fig. 1.
1. Handle - use 30W oil on release valve gears below handle and lightly grease handle at point
where it fits into socket with #2 tube grease.
2. Wheels - use 30W oil on axles and caster bearings.
3. Lifting Arm - inject #2 tube grease into tube fitting.
4. Saddle and Linkage - use 30W oil on all moving and pivoting parts.
5. Handle Socket Pivot Bolts - lubricate with 30W oil.
6. Plunger and Plunger Pin - Use #2 tube grease to lubricate connection between pump plunger
and pin in handle socket.
Lubrication Points
Advertisement
