Windshield Wipers; Rear Window Wiper; Instrument Panel Switches (Lower Left) - Subaru CROSSTREK 2020 Quick Manual

WINDSHIELD WIPERS

To turn on the wipers, press the wiper control
lever down one position for intermittent, two
positions for low speed, or three positions for
high speed. When the lever is in the
intermittent position, rotate the dial to adjust
the operating interval of the wipers. To turn the
wipers off, return the lever to the "OFF"
position. For a single wipe, move the lever up
one position.
Pull the lever toward you to spray washer fluid.
The washer will spray until you release the lever, then wipe twice.

REAR WINDOW WIPER

Rotate the end of the lever up one position for
intermittent, or two positions for continuous
wipe.
When the lever in is the intermittent position,
the wiper operates at intervals corresponding
with vehicle speed. When you move the select
lever to the "R" position, the wiper will switch
to continuous operation. It will return to
intermittent when you move the select lever
out of "R".
Rotate the dial up from the continuous wipe position or down from the off position to spray
washer fluid. The washer will spray until you release the dial, then return to the previous
position and wipe twice.

INSTRUMENT PANEL SWITCHES (LOWER LEFT)

For more information, please refer to your
Owner's Manual and/or EyeSight Quick Guide.
1 Steering Responsive Headlights OFF (if
equipped)
2 Illumination Brightness (p. 22)
3 Vehicle Dynamics Control OFF
4 Auto Start-Stop OFF (if equipped) (p. 31)
5 Blind Spot Detection/Rear Cross Traffic
Alert OFF (if equipped)
CONTROLS
23