Pacific Antenna Active Antenna Manual page 5

Now, install the 0.1uf (marked 103) monolythic capacitors C3, C5 and C6 in the locations marked on the board.
Locate and install the 10uf electrolytic capacitor C4 in the location marked on the board.
Note that it has one lead longer than the other. That lead goes in the hole with the "+" symbol next to it on the
board. The opposite side of the capacitor body is also marked with a "-" to mark the negative lead side.
Inductor
Install the molded inductor L1 in the location marked on the board.
Note that this part is similar in appearance to a resistor but has a body that is usually tapered (thinner) in the
middle and is usually a different color than most resistors.
LED
Install the LED. It has specific polarity and must be installed only one way in the board or it will not work. It has
one lead that is longer (the anode=+) and one shorter (the cathode)
The body of the LED will also usually have a slight flat edge on the same side as the short (-)lead.
The circuit board has a "+" symbol next to one pad of the LED location. To install, insert the LED so that the long
lead (+lead) goes into the hole with the "+" symbol next to it on the board and the shorter lead goes into the other
hole.
5
ActiveAntenna20191111
Copyright Pacific Antenna 2019