Pacific Antenna Active Antenna Manual page 4

Inserting the Parts
Install the components listed in the table.
For resistors, and diodes, you can preform the leads by bending them down at a 90 degree angle.
Match the distance from the body to the holes in the circuit board where the part will be located.
Once each part is installed, bend its leads on the bottom of the board to hold it in place, solder the leads and clip
off the excess lead.
Resistors
Locate and install the Resistors R1, R2, R3, R4, R5 and R6 in the marked location on the board using the table
below as a guide.
If any doubt of the color code, use a multmeter to determine the correct parts by measuring their resistance.
Resistor Value
R1 1.5M
R2 1.5k
R3, R4 33K
R5 1K
R6 7.5K
Capacitors
Install the 0.001uf (1000pF, marked 102) monolythic capacitor C1 in the location marked on the board.
Note that C1 may have a brown or blue body depending on the supplier. Check the printed value on its body to
confirm.
Next, install the 0.01uf (marked 103) monolythic capacitor C2 in the location marked on the board.
ActiveAntenna20191111
Color Code
BROWN-GREEN-GREEN-GOLD
BROWN-GREEN-RED-GOLD
ORANGE-ORANGE-ORANGE-GOLD
BROWNN-BLACK-RED-GOLD
VIOLET-GREEN-RED-GOLD
4
Copyright Pacific Antenna 2019