Epson Stylus TX235 Service Manual page 56

Epson Stylus SX230 series / SX235W series / SX430W series / SX440W series
Main Frame Assy
CR Unit
Frame Base
Figure 4-10. Lubrication of the Main Frame Assy
Spread grease with brush.
Figure 4-11. Lubrication of the Scanner Housing Lower
Maintenance
<Part supply as ASP>
None
Main Frame Assy
<Lubrication status when
supplied as ASP>
---
<Lubrication Point>
1. Contact point (x1) on
2. Contact points (x4) on
<Type>
G-71
<Application Amount>
Appropriate amount
<Remarks>
Apply with injector.
Application Point
<Part supply as ASP>
Supplied as the Scanner
Unit
<Lubrication status when
supplied as ASP>
Lubricated
Guide rail
<Lubrication Point>
Guide rail of the Scanner
Housing Lower
<Type>
G-45
<Application Amount>
0.03 g x 3 points
<Remarks>
After applying with
injector, spread it with
brush in the direction of the
arrow.
Scanner Housing Lower
Application Point
the upper side of the
Main Frame Assy with
the CR Unit
the lower side of the
Main Frame Assy with
the CR Unit
Section A (See Cross-section view.)
Lubrication Points and Instructions
CIS Module Unit
Scanner Carriage
Section A (See Cross-section view.)
Figure 4-12. Lubrication of the Scanner Carriage (1)
Revision B
<Part supply as ASP>
Cross-section of section A
Supplied as the Scanner
Unit
<Lubrication status when
supplied as ASP>
Lubricated
<Lubrication Point>
Contact points (x6) on the
Scanner Carriage with the
CIS Module Unit
<Type>
G-74
<Application Amount>
Appropriate amount
<Remarks>
Apply with flux
dispenser.
Stir G-74 before use.
For section A, apply
grease over the area
shown in the Cross-
section view.
Application Point
56
Confidential