Store Settings; Exit Setup Mode - ARP Fridge Defend Troubleshooting Manual

ARP Control v5.x Troubleshooting Guide

2.22 Store Settings

2.23 Display Error Messages

2.24 Exit SetUp Mode

04/20/202 0 © 2013-2020 ARPC L.L.C. All rights reserved.
This setting restores the default settings that came with
the ARP when new. If Auto Tune is run by mistake, the
original settings can be restored by pressing the SetUp
button.
The display will flash:
and then return to the original screen. Proceed to the
next step to save your new settings.
The variable to save changes to SetUp is S--; any
settings that have been changed can be stored by
momentarily pressing the SetUp button as seen in the
next figure.
Release the SetUp button as soon as
StO has to be displayed for the control to save the new
settings. If you do not want to save settings, proceed to
Exit SetUp Mode section.
The Er0 variable holds any IEC error messages stored
for the life of the control. Thus, always write down the
date any errors are viewed for future reference. It is not
unusual to see some errors recorded due to the nature of
RV electrical systems.
The SetUp button will toggle through all errors recorded.
recorded.
If there are errors recoded, the first error message will
immediately appear, followed by the number of times this
particular error has been recorded. Use the SetUp button
to toggle through all of the error messages. Once the
error messages roll back to the first error recorded, use
the Display button to exit the
StO
will be display if no errors are
Er0 and return to AtO.
8
is displayed.