Defrost Setting/Iec Periodic Test; Software Version Reading; Serial Number Reading; Audible Alarm (5.1 Only) - ARP Fridge Defend Troubleshooting Manual

ARP Control v5.x Troubleshooting Guide
2.17 Defrost Setting/IEC
Periodic Test
For refrigerators that have a
defrost cycle that is timed to turn
off the fridge for 2 hours, such as

2.18 Software Version Reading

2.19 Serial Number Reading

2.20 Audible Alarm (5.1 only)

On/Off Display SetUp

2.21 Restore ARP Defaults

04/20/202 0 © 2013-2020 ARPC L.L.C. All rights reserved.
the Norcold 1200, 2110, N3150, .... the
override the defrost cycle thereby providing improved
cooling in warm weather.
on is the default setting.
periodic test of the ARP occurs every 24 hours. In
addition, the factory defrost cycle is defeated resulting is
a cooler fridge in hot weather. See our defrost fans for
fridge.
Use the right button to toggle to the
PEr = oFF, the IEC periodic test of the ARP is not
preformed. Nor does the ARP defeat the defrost cycle,
thus the fridge runs with its factory defrost cycle.
The next setting is the software version of the control.
This software version example is
Fan Control version.
For the non fan-control version this value would be 4.0. If
you are using this manual your software version should
be either 5.0 or 5.1.
The next two settings display the ARP control serial
number. Following is an example of what the display will
flash out for the serial number 65,535:
This setting controls the Audible Alarm or beeper.
on is the default setting. For some IEC tests the alarm
will sound while the display shows the error that resulted
in the alarm.
Use the SetUp button to toggle the alarm to
prevent the alarm from sounding. Save setting with S--.
PEr
Per = on means the IEC
oFF setting. When
4.1 which is the ARP +
7
setting can
oFF to