Contents
Connecting to a WPS network
If your wireless router support WPS (Wi-Fi Protected Setup™) your HEOS wireless speaker can optionally connect to your
network using the "Push Button" method by following these steps:
Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.
1. Press the WPS button on your router.
2. Within 2 minutes, rapidly press the Connect button 3 times (within 2 seconds of each press).
3. The LED on the front of the speaker will flash green for several seconds as it connects to your WPS router.
4. When the connection is complete, the LED on the front of the speaker will turn solid blue.
Resetting your speaker
Resetting your speaker will clear out the wireless network info, EQ, and name but retain it's current software. You will have to use
Settings - Add Speaker to reconnect the speaker to your home network before it can be used.
To reset your speaker, press and hold the Connect and Bluetooth buttons located on the back of the HEOS speaker for 5 seconds
until the front LED begins to flash amber.
Setup
Use
Solution
Solution
Troubleshooting
66
Status LED
Appendix
Refer to Page
Refer to Page
7
–