Fig. 23 - Typical Wiring For Manual Control Fridge; Fig. 24 - Remote Mount, Or High Amperage Fridge Application; Fig. 25 - Mount Additional Cooling Fans; Arp + Fan Control - ARP Fridge Defend General Install Manual

ARP Control v5x General Installation Guide
From Relay 87a
to Interrupter
ARP v3.x Thermocouple (TC) Interrupter Norcold P/N: 621737
NOTE: The Periodic Test for 5.x control must be turned off for manual control fridge. See the
Troubleshooting Guide section 2.17 Defrost Setting/IEC Periodic Test
Fig. 24

ARP + FAN CONTROL

10.1 Mounting Fan Sensor

The ARP + Fan Control will help increase the
efficiency of your fridge by forcing air into the
cooling unit compartment with fans. The fans
04/20/20
Yellow from ARP to Relay 86
Clamped Relay Tyco
P/N 0-1432793
-
GND
RV
Relay
85 Power
Supply
To Gas Safety
Valve
Fig. 23 Typical Wiring for Manual Control Fridge
–
Remote Mount, or High Amperage Fridge Application
–
Fig. 25 Mount Additional Cooling Fans
–
20 © 2013 - 2020 ARPC L.L.C. All rights reserved.
+
From Interrupter
to Relay 30
will only run when needed, thereby saving
energy. Fig. 25 shows the location on the
cooling unit to install the fan sensor. The fan
sensor is installed on the bottom absorber
coil. The sensor can be clamped to the
Senor
Inside
Boiler
Housing
To Flame
Sensor
Boiler Housing
19
.