Table of Contents
Advertisement
A:
Check if the signal cable between the computer and the LCD Display is securely con-
nected.
(Refer to Connecting a Computer)
Problems Related to the Screen
Note
Problems related to the LCD Display screen and their solutions are listed below.
Q:
The screen is blank and the power indicator is off.
A:
Ensure that the power cord is firmly connected and the LCD Display is on.
(Refer to Connecting a Computer)
Q:
"Check Signal Cable" message.
A:
Ensure that the signal cable is firmly connected to the PC or video sources.
(Refer to Connecting a Computer)
A:
Ensure that the PC or video sources are turned on.
Q:
"Not Optimum Mode" message.
A:
Check the maximum resolution and the frequency of the video adaptor.
A:
Compare these values with the data in the Preset Timing Modes Chart.
Q:
The picture rolls vertically.
A:
Check if the signal cable is securely connected. Re-connect it, if necessary.
(Refer to Connecting a Computer)
Q:
The image is not clear; picture is blurred.
A:
Run Frequency Coarse and Fine tuning.
A:
Turn on again after removing all accessories (video extension cable, etc.)
A:
Set the resolution and frequency to the recommended ranges.
Q:
The picture image is unstable and shakes.
A:
Check if the resolution and frequency set for the computer video card falls in the range
supported by the LCD Display. If not, reset them referring to the current Information
under the LCD Display menu and Preset Timing Modes
Q:
Ghost images appear in the picture.
A:
Check if the resolution and frequency set for the computer video card falls in the range
supported by the LCD Display. The optimum resolution and refresh rate for this monitor
is listed in the Specifications section under General Specifications. Other supported
resolutions and refresh rates are listed in the Preset Timing Modes table also in the
Specifications section.
Q:
The image is too light or too dark.
A:
Adjust the brightness and contrast.
Troubleshooting
Advertisement
Table of Contents
Troubleshooting
