Reset Controller - Samsung SyncMaster 230MXN User Manual

• Press G (grid) to clear the screen and display a grid that you can use as a drawing guide
(default setting).
• Press L (line) to draw solid lines on the screen (default setting).
• Press D (dots) to draw dotted lines on the screen, where each dot represents a point
reported by the touch sensor.
• Press the Space Bar to clear the screen.
Restore Factory Settings
Software
The Reset Software option is useful if you have reconfigured the MT 7 software and need to
get back to a working state. This option will restore supplier factory configuration settings. If
none exist, it will reset to 3M Touch System defaults.
Controller
The Restore Controller option is useful if you have reconfigured the controller and need to
get back to a working state. Pressing this button restores 3M Touch System factory-set sys-
tem defaults.
If after restoring controller factory defaults, you lose touch, you will need to reboot in order to
restore touch.
Note
You must perform a calibration after restoring controller defaults.

Reset Controller

Use this only at the direction of Technical Support. This command initializes the hardware
and the firmware, causes the controller to stop sending data, and recalculates the environ-
mental conditions (for example, stray and offset values). The Reset command also cancels
existing commands and returns the controller to normal operation.
Advanced Touch Options
Note
Important Note: Executing the Advanced Options may alter the performance of your touch
sensor or render it inoperable. You should be aware of expected results before executing any
option. If you are not familiar with the outcome of these settings, you should not be using
these options.
Using the Software