Advertisement
Installation Instructions:
EMG Models: JX, JAX, J-CS-X SYSTEM (4 /5-STRING)
Mounting the Controls:
Refer to Diagram #3
1) Remove the existing controls from the control plate
and mount the EMG controls as shown to the right.
Be sure the PC Board on the switch is facing the
same direction as the diagram shows.
Diagram #3
Diagram #4
J-X SYSTEM Page 3
Plug in the Pickups:
Refer to Diagram #3
1) Plug the Pickup cables onto the switch
PC Board as shown.
Neck Pickup to the NEK Input.
Bridge Pickup to the BRG input.
Neck Pickup Input
Bridge Pickup Input
Output Cable and Battery Installation;
Refer to Diagram #4
1) Plug the output cable from the control board to the output jack.
White to the Tip (T) terminal
Black to the Sleeve (S) terminal
Battery Black to the Ring (R) Terminal.
Refer to Diagram #5 for further clarity of the Jack terminals.
2) Plug the Red wire from the battery clip the the terminal on the
control board marked Red.
As mentioned before fitting the battery can be a problem.
Make sure the battery fits snuggly, but is easily removable.
Test the pickups by tapping on them while the instrument is
plugged in, and if everything seems OK, fasten the control
plate and adjust the pickups to your preference.
Output Cable and
Battery Positive
to the PC Board
Diagram #5
R
S
T
OUTPUT JACK
BOTTOM VIEW
Advertisement
