General Cleaning; After Use; Care & Maintenance - sunjoe TJ603E Operator's Manual

Fig. 8
light pressure to the handle in order to lift the blades and
facilitate the turn. Turn the product around using the wheels
as a guide. Gradually release pressure on the handle and
move the blades back to the ground.
m
WARNING!
Stop the motor if the product strikes a
power supply, and let it cool completely. Inspect the product
thoroughly for damage and have any damage repaired before
restarting.
Extensive vibration of the product during operation is an
indication of damage. Immediately stop the motor and
promptly inspect and repair the tool.

After Use

and let it cool completely.
Check, clean, and store the product as described below.
Care + Maintenance
The Golden Rules for Care
m
WARNING!
the product from the power supply, and let the product cool
completely before inspecting, cleaning, or performing any
other maintenance task.
and before storage.
prolong the life of the product.
tool.
m
WARNING!
Only perform the repairs and maintenance
work described in this manual. Any other work must be

General Cleaning

that are hard to reach.
and brush.
NOTE: Do not use chemical, alkaline, abrasive, or other
aggressive detergents or disinfectants to clean this product as
such substances might damage the tool's surfaces.
necessary
Cleaning the Underbody + Working Tool
m
WARNING!
near the working tool. Use appropriate tools (e.g a wooden
stick) when necessary; never use your bare hands!
Use a brush or another implement to remove soil from the
working tool.
All nuts and bolts must be checked periodically for
tightness before operation. After prolonged use, especially
in sandy soil conditions, the working tool will become worn
reduced and the working tool should be replaced.
supply,
lubricate the blades after each use.
Maintenance
m
WARNING!
personal injury. Before servicing, repairing, or inspecting
the unit, turn the motor OFF and disconnect the extension
cord. Wait for the blades to completely stop rotating before
conducting inspection, cleaning, or maintenance.
Before and after each use, check the product and accessories
(or attachments) for wear and damage. When necessary, only
use identical replacement parts that are approved by the
manufacturer.
m
WARNING!
housing, gear box, etc.) on the machine may cause burns.
IMPORTANT!
Wear protective gloves when cleaning or maintaining the
machine.
machine down with water (especially water under
pressure) when cleaning the machine.
10
Wear safety gloves when working on or
Unexpected blade movement may cause
Contact with hot components (e.g. motor