Mount to the Wall
Locate the Wooden Studs
15
This step applies to wooden stud wall installation only. Determine and mark the exact
locations of two stud centers on the wall. Wooden studs should be spaced so that the
weight of the screen is distributed evenly. In order to achieve this, mark the studs that
are separated by at least one-third to one-half of the projector screen's total width.
For example: if the projector screen is 100" wide, look for two studs that are spaced
between 33" to 50" apart. Stud spacing 48" apart would be ideal in this case.
Mark the Drill Locations for the Hanging Brackets
16
Top Hanging Brackets:
on the wall, measure
approx. 3/4"
and mark 3/4" down
from the top edge of the
desired frame location.
IMPORTANT
they are marked on the
center of the studs and
verify they are level.
17
Wooden Stud Wall Mounting: using a power drill
and 3/32" drill bit, drill pilot holes of 3/32" (2.38 mm)
diameter and approx. 1.18" (30 mm) depth. Secure
each Wall Mounting Screw by using a socket
wrench, leaving about 1/4" of thread exposed.
Concrete Wall Mounting: using a power drill and a
3/8" masonry drill bit, drill mounting holes of 3/8"
(10 mm) diameter and approx 1.18" (30 mm) depth
at the marked locations. Insert Concrete Anchors
and hammer them into the wall, secure each Wall
Mounting Screw by using a socket wrench, leaving
about 1/4" of thread exposed.
18
Slide the Hanging Brackets until they line up with
the secured mounting hardware. With an assistant, lift the
screen gently onto the secured Wall Mounting Screws so that
the keyholes on the Hanging Brackets fit over the screws.
IMPORTANT
Verify that each Hanging Bracket is properly secured before releasing
the projector screen to avoid injuries and property damages.
Bottom Hanging
Brackets: measure and
record the distance from
Record
the top of the bracket to
Distance
the top of the matching
make sure
bottom bracket on the
assembled frame. Mark
this distance on the wall
from the top marked
location.
Different wall types require
different types of hardware.
Hardware is included for wooden
stud and concrete wall mounting
only. For other wall types, please
consult a professional.
Use the anchors provided
for concrete wall mounting only.
Do not use them for drywall.
Also, use socket wrench for Wall
Mounting Screws to prevent
damages to the screw heads.
Do not use power drill to
fasten the Mounting Screws.
Socket
Wrench
1/4"
11
INSTALLATION MANUAL
www.qualgear.com | 2 Year Limited Warranty | Version: December 2015