Connecting The Antennas - Samsung HT-DM150 Instruction Manual

Connecting the Antennas

FM antenna connection
FM Antenna (supplied)
1
Connect the FM antenna supplied to the FM 75 COAXIAL terminal as a
temporary measure.
2
Slowly move the antenna wire around until you find a location where
reception is good, then fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75 coaxial cable (with a
standard type connector), disconnect the supplied
FM antenna.
17
AM(MW) antenna connection
If AM reception is poor, connect an outdoor
AM antenna(not supplied).
AM Loop Antenna
(supplied)
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
1
Connect the AM loop antenna supplied to the AM and
2
If reception is poor, connect an outdoor single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna connected).
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
Cooling Fan
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
1 2 3
terminals.
18