Connecting 2U Expansion Enclosures To The Control Enclosure - IBM FlashSystem 5000 Series Quick Installation Manual

Other expansion enclosure parts
Table 34 on page 62 summarizes the part numbers and feature codes for other parts. The values are the
same for all systems that support the 5U expansion enclosure.
Table 34. Other expansion enclosure parts
FRU Part Number
00AR317
00AR439
01LJ114
01LJ116
01LJ118
01LJ120
01LJ122
01LJ124 (for use with enclosure
FRU P/N 01LJ112)
01LJ860 (for use with enclosure
FRU P/N 01LJ607
01LJ126
01LJ128
01LJ130
01LJ132
01LJ134
01LJ607
39M5388

Connecting 2U expansion enclosures to the control enclosure

If you have 2U expansion enclosures in the rack, you must connect them to the control enclosure.
About this task
This task applies if you are installing one or more expansion enclosures.
62 IBM FlashSystem 5000 : FlashSystem 5000 Quick Installation Guide
Description
3 m 12 Gb SAS Cable (mSAS HD)
6 m 12 Gb SAS Cable (mSAS HD)
Rail kit
Front fascia (4U front cover)
Display panel assembly
PSU fascia (1U cover)
Power supply unit (PSU)
Secondary expansion module
Fan module
Expansion canister
Cable management arms (CMA)
Top cover
Fan interface board
Enclosure
Note: Replaces enclosure FRU P/N
01LJ112.
16A power cord C19/C20 2 m
Comments
The fascia must be removed to
access the power supply units.
The expansion enclosure contains 2
PSUs. Each PSU requires a
C19/C20 power cord.
The expansion enclosure supports
two-secondary expansion modules.
CAUTION: Use caution
when you are removing or
replacing a secondary
expansion module from an
enclosure with FRU part
number 01LJ112. Avoid
contact with the connectors
on the main board.
The expansion enclosure contains
four fan modules.
The part contains the upper and
lower CMA.
Includes the drive board, signal
interconnect board, and internal
power cables, in an otherwise
empty enclosure.