Direct Capturing Mpeg Video - ADS Technologies USB Instant DVD User Manual

54 VIDEOSTUDIO USER GUIDE

Direct capturing MPEG video

Capturing video directly from your camcorder straight to MPEG format is one of the most
exciting developments in computer video. Capture from Instant DVD straight to MPEG-1
(VCD) or MPEG-2(SVCD or DVD), depending on your needs and skip the task of having to
capture in other formats only to convert it later.
To capture video in MPEG format:
1. Connect your camcorder or VCR to your
Instant DVD. Switch it on and set it to Play
(or VTR / VCR) mode. Check your device
manual for specific instructions.
2. In the Capture Step, be sure MPEG is
selected from the Format list.
3. Instant DVD Capture Plug-in will be
detected automatically. Use only this capture
plug-in when capturing video from Instant
DVD.
4. You should see video playing in the Preview
Window.
5. Click Capture Video to start capturing.
6. Click Capture Video again or press [Esc] to
stop capturing.
Tips:
Capture menu items are grayed out in the Playback Mode. If this happens in the Capture Mode, check
•
if your video capture devices are correctly installed.
• A delay in capture may be due to the confirmation dialog box or connection between devices.
It is better to rewind your tape to an earlier point before capturing and just trim the video later.
• The normal number of dropped frames is zero. If any frames are dropped, check if the
on your hard drive is enabled.
VS6-B.p65 54
DMA setting
6/4/2002, 12:23 PM