ADS Technologies USB Instant DVD User Manual page 13

Check Contents - Wire it Up! - Plug it In! - Install Optimize System- - Verify Installation - Set Audio Mixer - Installation Summary
2. Wire It Up! (cont'd)
2. Connect your USB Instant DVD
Audio to the Sound Card on your PC.
This will send Audio from your USB
Instant DVD to your PC.
Connect one end of your
male to male stereo audio cable
to the Audio Out jack at the back of
your USB Instant DVD.
Connect the other end to the Line In
jack on your sound card of your PC.
Check your diagram of connectors on
your Sound Card
If you want to send captured or edited video
back to your TV or VCR for viewing or recording,
continue steps 3 & 4. If you only want to preview
& capture the video on your PC, skip to the Plug
It In section on page 6.
3. Connect your USB Instant DVD to
your TV or VCR. This will send cap-
tured or edited video back to your TV
or VCR for viewing or recording.
Connect
Out" on Instant DVD
Connect other end to Video IN on your
TV or VCR.
CapWiz manual.p65
USB INSTANT DVD INSTALLATION
(E) 6 ft.
(G) RCA cable
to "Video
11
USB Instant DVD
PC Sound Card
USB Instant DVD
A/V Source
6/4/2002, 12:21 PM
11