Table of Contents
Advertisement
3.5. Connecting the equipment in the installation structure
When equipment units are added to the installation, they appear in the structure with their name in red,
preceded by the "disconnection" icon. While their status is shown as disconnected, these equipment units
are not operative.
To connect the equipment, proceed as follows:
1. In the installation structure, right click with the mouse on the
disconnected equipment unit.
2. Click on Connect Equipment. The connection icon appears and the
name of the equipment unit is shown in green.
3.6. Sending configurations to a UMX-CC card
1. Before sending configurations to any equipment unit, it is advisable to save the configuration. To do
this, from the P.A. Manager software installation screen, open the File menu and select Save.
1. On the installation tree, right click with the mouse on the name of the UMX-CC card and select the
option Send configurations.
2. A progress bar appears. Upon completion, click on OK.
NOTE: If one UMX-CC card is added or its configuration is modified, it is necessary to send configurations to all
the Optimax equipments in the installation.
4. CONFIGURATION OF THE UNIT IP ADDRESS BY
SOFTWARE
It is possible to change the IP address of the UMX-CC card by
means of the DIP switches situated on the underside of the
unit or remotely through the software.
To make the change by software, from the installation screen
of the P.A. Manager software right click with the mouse on the
name of the unit and select the option Web Connection (1).
If the PC is remote with respect to the installation, open the
Internet browser and enter the IP of the unit in the address
bar (for example: http://10.1.1.2). This IP address is the
address configured through the IP configuration DIP switches
of the UMX-CC card.
UMX-CC version 1.0
UMX-CC
AUDIO IP MANAGEMENT CARD
FOR UMX-02/0 MODULAR MATRIX
= Equipment disconnected
= Equipment connected
R&D Department
(1)
13
Advertisement
Table of Contents
