Table of Contents
Advertisement
Technical Data
Type
Mains connection
Max. power / current: 24V /VACUU•BUS
Nominal current
Degree of protection IP
Max. permitted ambient temperature during operation
Max. permitted ambient temperature during storage
Permitted relative atmospheric moisture during operation
(no condensation)
Max. permitted power draw at connection vacuum pump for
ohmic (inductive) load
Fuse
Dimensions
Mass
We reserve the right for technical modification without prior notice!
Replacing the device fuse
Switch off the device and disconnect it from mains before replacing the fuse. After
disconnecting from mains wait two minutes to allow the capacitors to discharge.
Identify and eliminate the cause of failure before switching on the device again.
➨ Keep the snap-fit squeezed and pull the fuse holder out.
➨ The fuse holder contains two fuses of the same type. Replace the defective fuse
by a fuse of the same type (see "Technical data").
➨ Insert the fuse holder into the device until it snaps.
fuse holder
Das Dokument darf nur vollständig und unverändert verwendet und weitergegeben werden. Es liegt in der Verantwortung des
Anwenders, die Gültigkeit dieses Dokumentes bezüglich seines Produktes sicher zu stellen.
Documents are only to be used and distributed completely and unchanged. It is strictly the users' responsibility to check carefully
the validity of this document with respect to his product.
Seite/page 12/20
TM
8(4) A bei 250 V~ / 8(6) A bei 125 V~
VMS-B-Module
100-230 V, 50-60 Hz
1.1A
0.8 A
20
+10°C to +40°C
-10°C to +60°C
30% to 85%
2 x 250 V
179 mm x 108 mm x 61 mm
0.7 kg
Advertisement
Table of Contents
