Advertisement
Quick Links
Installation / Operation
Manual
Filter for removal of
Arsenic III, Arsenic V,
Iron+Manganese+Hydrogen Sulfide
IMPORTANT: Test your water quarterly to ensure proper system operation!
Five postage pre-paid test bottles included!
To reorder, visit
watercontrolinc.com/element33-arsenic-removal
or scan this QR code:
BrassMaster and BrassMaster Plus Technical Video Library:
https://watercontrolinc.com/residential-technical-support/residential-technical-videos
BrassMaster technical videos demonstrate how to set up or remove the control module. If replacing your
control module, please use the (downloadable)
Module Order
Form.
Advertisement
Related Manuals for Water Control BrassMaster
Summary of Contents for Water Control BrassMaster
- Page 1 To reorder, visit watercontrolinc.com/element33-arsenic-removal or scan this QR code: BrassMaster and BrassMaster Plus Technical Video Library: https://watercontrolinc.com/residential-technical-support/residential-technical-videos BrassMaster technical videos demonstrate how to set up or remove the control module. If replacing your control module, please use the (downloadable) Module Order Form.
-
Page 2: System Capabilities
(in children). Always install and operate this system according to manufacturer instructions. Test water quar- terly to verify proper system operation. Water Control offers inexpensive, non-certified test services (the first 5 test bottles are included free with system). System Capabilities... -
Page 3: Installation Procedure
Installation Procedure 1. Identify installation location. ELEMENT33 piping should originate shortly after incoming water supply shutoff, but just after any outside water lines. IMPORTANT: there must not be any filters installed upstream of the ELEMENT33, or insufficient water pressures may af- fect operational performance. -
Page 4: Start-Up Procedure
Start-Up Procedure Placing unit into service Normal Operation Mode Icon While in service, the Data Display alternates between time of day, volume remaining or days to regeneration. The Flow Indicator flashes when outlet flow is detected. The Faucet Icon flashes if a regeneration cycle has been queued. 1. - Page 5 Start-Up Procedure Setting current time of day Setting Current Time / Day 1. Press either the Up or Down buttons to adjust current time of day by one digit. Push and hold either up or down set button to adjust current time of day display by several digits. Ensure the AM/PM setting matches the current time of day.
- Page 6 The most common / default setting is 12:30 AM. IMPORTANT: this regeneration time should be offset from any additional water treatment’s regeneration time by at least 1 hour to ensure adequate regeneration pressure. Contact Water Control if you have multiple treatment systems installed.
- Page 7 QR code: BrassMaster and BrassMaster Plus Technical Video Library: https://watercontrolinc.com/residential-technical-support/residential-technical-videos BrassMaster technical videos demonstrate how to set up or remove the control module. If replacing your control module, please use the (downloadable) Module Order Form. For factory module support contact:...
- Page 8 Limited Warranty Water Control Corporation warrants the control valve to be free of manufacturer’s defects for a period of 5 (five) years from the date of installation, and the fiberglass reinforced mineral tank, and plastic brine tank (where applicable), to be free from leaking due to manufacturers defects for a period of 5 (five) years.