Table of Contents
Advertisement
Quick Links
LS MODELS
Nitrate-Only Filter
Installation / Operation
Manual
IMPORTANT: Test your water 2x annually (every 6 months) to ensure proper system operation!
Two postage pre-paid test bottles included!
To reorder, visit
watercontrolinc.com/nitramax-nitrate-removal
or scan this QR code:
BrassMaster and BrassMaster Plus Technical Video Library:
https://watercontrolinc.com/residential-technical-support/residential-technical-videos
BrassMaster technical videos demonstrate how to set up or remove the control module. If replacing your
control module, please use the (downloadable)
Module Order
Form.
Advertisement
Table of Contents
Related Manuals for Water Control Brassmaster Plus+ NitraMAX LS Series
Summary of Contents for Water Control Brassmaster Plus+ NitraMAX LS Series
- Page 1 LS MODELS Nitrate-Only Filter Installation / Operation Manual IMPORTANT: Test your water 2x annually (every 6 months) to ensure proper system operation! Two postage pre-paid test bottles included! To reorder, visit watercontrolinc.com/nitramax-nitrate-removal or scan this QR code: BrassMaster and BrassMaster Plus Technical Video Library: https://watercontrolinc.com/residential-technical-support/residential-technical-videos BrassMaster technical videos demonstrate how to set up or remove the control module.
- Page 2 Always install and operate this system according to manufacturer instructions. Test water every six months to verify proper system operation. Water Control offers inexpensive, non-certified test services (the first 2 test bottles are included free with system). Nitrate (+ Nitrite + Sulfate) Filter...
- Page 3 Installation Procedure 1. Identify installation location for NitraMAX system. Piping should be such that all house- hold water, with the exception of outside hydrants, flows through NitraMAX. This system and installation must comply with state and local laws and regulations. NitraMAX must be supplied with soft water (<3 GPG).
- Page 4 Start-Up Procedure Placing unit into service Normal Operation Mode Icon While in service, the Data Display alternates between time of day, volume remaining or days to regeneration. The Flow Indicator flashes when outlet flow is detected. The Faucet Icon flashes if a regeneration cycle has been queued. 1.
- Page 5 Start-Up Procedure Setting current time of day Setting Current Time / Day 1. Press either the Up or Down buttons to adjust current time of day by one digit. Press and hold either the up or down button to adjust current time of day display by several digits. Ensure the AM/PM setting matches the current time of day.
- Page 6 Start-Up Procedure User programming (cont’d) 3. Adjust Regeneration Time: Press the Extra Cycle button to advance to next option. This setting determines the time of day that the unit will enter the regeneration cycle. The most common / default setting is 2:00 AM. NOTE: If installed downstream of other equipment, program all equipment regen times such that each piece of equipment has a minimum of 90 minutes (each) for regeneration.
- Page 7 The required (downloadable) form to have your module replaced is also located at this site. Please contact your dealer or Water Control Corporation for module support. Salt Maintenance Failure to maintain salt in the brine tank will allow nitrates into your water! You must keep salt in the brine tank.
- Page 8 Limited Warranty Water Control Corporation warrants the control valve to be free of manufacturer’s defects for a period of 5 (five) years from the date of installation, and the fiberglass reinforced mineral tank, and plastic brine tank, to be free from leaking due to manufacturers defects for a period of 5 (five) years.
Need help?
Do you have a question about the Brassmaster Plus+ NitraMAX LS Series and is the answer not in the manual?
Questions and answers