Siemens VS08G2090 Instructions For Use Manual page 15

en
Figure 5
Unlock the telescopic tube by pushing the
sliding button in the direction of the arrows
and then set it to the required length.
Figure
6
Holding the power cord by the plug, pull
out the required length and plug it into the
mains socket.
=> Readiness display lights up in blue.
Figure 7
To switch your vacuum cleaner on and off,
press the On/Off button in the direction of
the arrow.
Suction adjustment
Figure
8
Pressing the suction adjustment switch in
the direction of the arrow reduces or
increases the suction power.
The LED on the appliance lights up to
display the suction level.
Low power range:
For vacuuming delicate materials, e.g.
curtains.
Medium power range:
For day-to-day cleaning when there is little
dirt.
High power range:
For cleaning hard-wearing floor coverings
and hard floors, and when there is a lot of
dirt.
Figure
9
Pushing the sliding switch too far in the
direction of the arrow switches off the
vacuum cleaner and puts it into "Stand by"
mode.
=>The lowest power level flashes in blue
Pushing the sliding switch in the opposite
direction switches the appliance back on.
Figure
10
The electromatic brush can be switched on
or off while you are vacuuming by pressing
the knob.
Vacuuming
You have purchased an extremely powerful
device.
The highest suction setting is therefore only
recommended for heavily soiled, durable
carpeted and hard floors.
Floor nozzle with rug lifter and
unlatching sleeve
Figure 11
Adjusting the floor nozzle:
For cleaning rugs and
carpets
For cleaning hard floors
Figure
12
When you pull the floor nozzle backwards,
the rug is lifted, allowing you to clean
underneath the edge.
Electromatic brush
For notes on the use and maintenance of the
electromatic brush, see the instruction
manual provided.
Vacuuming with accessories
Figure 13
Pull the combination tool in the direction of
the arrow to remove it from the tool holder.
a) Crevice nozzle
For vacuuming in crevices and corners.
For difficult to get to places, the combina-
tion tool can be extended in two stages by
pulling out the crevice nozzle.
Extend the crevice nozzle to the second
stop until you can hear it engage.
The crevice nozzle can be pushed back
together by undoing the telescopic tube
locks (press in the direction of the arrow).
b)Upholstery nozzle
For cleaning upholstery, curtains, etc.
c) Furniture brush
For window frames, cabinets, profiles etc.
Fold the upholstery nozzle over in the
direction of the arrow.
To extend the brush ring, turn it in the
direction of the arrow.
=>
=>
11