Recording A Programme Immediately; Recording A Programme With Automatic Stop - Samsung SV-DVD440 User Manual

Recording a Programme
Immediately
Before recording a programme, you must have preset
the corresponding station (unless you are recording via
an external video source). If you have not done so,
refer to pages 11 and 12.
1
Switch on the television.
2
To monitor the programme being recorded, select
the television channel reserved for use with your
DVD-VCR (or the AV input if used).
3
Insert the cassette on which the programme is to be
recorded, with the window visible and the safety tab
intact or the opening covered with adhesive tape.
Result: The DVD-VCR is switched on automatically.
4
Select:
The station to be recorded using the PROG
( or ) buttons
or
The AV1, AV2 or AUX(SV-DVD440/SV-DVD540
Only) source using the INPUT SEL. button for a
satellite tuner or external video source
Result: The station number is displayed and the
programme can be seen on the television.
5
Select the recording speed by pressing the SPEED
button as many times as required (see page 18).
6
Hold REC ( ) down for a while to start recording.
Result: The record indicator appears on the
television and DVD-VCR display. An index
is recorded on the tape (see page 25).
7
To stop recording, press
If your DVD-VCR ejects the cassette when you
start recording, check to make sure that the
cassette's safety tab is intact or that the
opening (created by a broken safety tab) is
covered with adhesive tape.
If you reach the end of the tape while
recording, the cassette rewinds automatically.
once.
ENG-19
Recording a Programme with
Automatic Stop
This function enables you to record up to nine hours
(LP) of programmes.
Your DVD-VCR stops automatically after the requested
length of time.
1
Switch on the television.
2
To monitor the programme being recorded, select
the television channel reserved for use with your
DVD-VCR (or the AV input if used).
3
Insert the cassette on which the programme is to
be recorded, with the window visible and the safety
tab intact or the opening covered with adhesive tape.
Result: The DVD-VCR is switched on automatically.
4
Select:
The station to be recorded using the PROG
( or ) buttons
or
The AV1, AV2 or AUX(SV-DVD440/SV-DVD540
Only) source using the INPUT SEL. button for a
satellite tuner or external video source
Result: The channel number is displayed and the
programme can be seen on the television.
5
Select the recording speed by pressing the SPEED
button as many times as required (see page 18).
6
Hold the REC button ( ) down for a while to start
recording.
Result: The record indicator appears on the
television screen and DVD-VCR display.
An index is recorded on the tape
7
Press the REC button ( ) several times to increase
the recording time in:
30-minute intervals up to four hours
1-hour intervals up to nine hours
Result: The length is displayed on the television
displays. The selected programme is
recorded for the length of time requested.
At the end of that time, the DVD-VCR stops
recording automatically and power off.
8
If you wish to cancel the recording before the end,
press STANDBY/ON.
If the end of the tape is reached while recording:
The recording stops and power off.
This function is not available in DVD recording
LENGTH 2:30
SET LENGTH :
PRESS REC