Using The Showview - Samsung DVD-CM500 Instruction Manual

VCR
GB
Standard
ShowView
Code
PR Day Start
WE 01 19 : 00
5
32

Using the ShowView

1
Timer Method
VideoPlus
Code : 0 - 9
Correct :
Stop Speed V/P
19 : 30 SP Off
: :
: :
: :
: :
: :
Before presetting your DVD-VCR:
Switch on both the television and your DVD-VCR
Check that the date and time are correct
Insert the cassette on which the programme is to be
recorded (safety tab intact)
Up to six programmes can be preset.
1
To enter a ShowView
and OK or ❿ buttons to select
Press the or
❷
Result: A message is displayed to allow you to enter the
ShowView
If all six programmes have been set, the message
is full is displayed. Refer to page 35 if you wish to
cancel a preset recording.
2
Press the numeric buttons to enter the code opposite the
programme that you wish to record in your television magazine.
If you wish to correct the
entering:
Press the ➛ button until the digit to be corrected is
cleared
Enter the correct digit
3
Press the OK button.
Result: The information concerning the programme is
displayed.
When using the
stored stations, the programme number flashes. This one
time, you must enter the station number manually by
pressing the
if:
The programme number or times flash
You wish to modify the programme
4
If the programme and times are correct, press the RETURN
button.
5
Press the STANDBY/ON button to activate the timer.
6
Refer to page 35 if you wish to:
Check that your DVD-VCR has been programmed correctly
Cancel a preset recording
The numbers next to each TV programme listing are
ShowView code numbers, which allow you to
programme your videorecorder instantly with the
remote control. Tap in the ShowView code for the
programme you wish to record.
™ ShowView is a trademark of Gemstar Development Corporation. The ShowView system
is manufactured under licence from Gemstar Development Corporation.
, press the TIMER button.
ShowView
code.
code that you are
ShowView
function for the first time with
ShowView
or buttons. Refer to the following page
❷
Timer