Craftsman CMEBL7000 Instruction Manual page 9

Fig. K
1
Blower Mode (Fig. L)

CAUTION:
Wear a filter mask if the operation is dusty. Use
of gloves, long pants and substantial footwear is
recommended. Keep long hair and loose clothing
away from openings and moving parts. THIS BLOWER
IS FOR HOUSEHOLD USE ONLY.
nOTE: Ensure the blower is switched off and disconnected
from the power supply before attaching or removing the
blower tubes.
The blower tube must be assembled to the housing
before use.
• Hold the blower with both hands as shown in Fig. L
and sweep from side to side with the nozzle several
inches above the surface. Slowly advance keeping the
accumulated pile of debris in front of you.
Fig. L
Vacuum Mode (Fig. A, G, I, M)

WARNING:
and disconnected from the power supply.
To fit the backpack collection bag assembly to product:
1. Remove blow tube.
2. Push the flexible collection tube assembly
power head 2 until it is in the fully locked position and
an audible click is heard. (Fig. I).

WARNING:
without blow tube or flexible collection tube securely
Always wear safety glasses.
Ensure product is switched off
12 onto the
Do not operate blower
in place. Never reach down into housing through
tube hole.
3. Unlatch the fan cover
head. Refer to Figure G for further instruction.
4. Attach the vacuum tube assembly to the power head
(Fig. H) by locating the assembly as indicated by arrow,
then pivot about this point until the locking/release
catch is fully engaged and an audible click is heard.

CAUTION:
vacuum tube assembly is securely seated and latched
into position.
5. Unzip the collection bag
6. Connect the cord on the power head to the power supply.
7. Position the tube slightly above the debris/leaves. Turn
the blower/vac on, then using a sweeping motion the
debris/leaves will be sucked up the tube, mulched and
deposited into the collection bag (Fig. M) .
8. As the collection bag fills, the suction power will
decrease. Turn the blower/vac off and unplug from
power supply before emptying collection bag.
Fig. M
Emptying Back Pack Collection Bag (Fig. N)

CAUTION:
COLLECTION BAG WITHOUT FIRST TURNING OFF AND
UNPLUGGING THE VACUUM.
1. Empty the back pack collection bag
bag zipper.
Fig. N
English
14 from the bottom of the power
CUT HAZARD. Ensure the
8 .
NEVER REMOVE THE
8 by unzipping the
8
7