Assembly And Adjustments - Craftsman CMEBL7000 Instruction Manual

ASSEMBLY AND ADJUSTMENTS


WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Blower Tube Assembly (Fig. A, C, D, E)
1. Rotate the fan cover
latch fan cover 9 as shown in the inset of Figure C.
Rotate the center of the fan cover clockwise to close the
interlock switch.
nOTE: Unit will not operate in blow mode without fan
cover closed and the center of the fan cover must be
rotated clockwise to close the interlock switch.
nOTE: Align the upper and lower tubes as shown in
Fig. C.
2. Push the lower blower tube
blower tube 3 , until the tubes click into place.
nOTE: Blow tubes must be assembled to the power
head before use.
nOTE: Never operate without both lower and upper
tubes assembled.
3. In the interest of safety, it is not intended for the blower
tubes to be separated once assembled.
4. Push the blower tube assembly onto the power head
until it is in the fully locked position (Fig. D).
5. Use the air concentrator attachment
to a tighter area. Add the attachment to the assembly as
shown in Fig. E. Push on until hole in tab engages raised
post on tube.
Fig. C
Fig. D
To reduce the risk of
9 counterclockwise. Close and
4 firmly into the upper
5 to target air flow
3
2
9
2
Fig. E
Vacuum Tube Assembly (Fig. F, G, H)
NOTICE:
off and disconnected from the power supply before
attaching or removing the vacuum tube. The vacuum
tube and collection bag must be assembled to the
housing before use. The vacuum tubes must be
assembled together before use.

CAUTION:
assembly is securely seated and latched into position.
1. Vacuum tubes must be assembled together before use.
2. Align the notches and the triangles on upper
lower vac tubes
3. Push the lower tube firmly into the upper tube, until the
triangles click into place. (Never operate apart).
nOTE: In the interest of safety, it is not intended for the
2
tubes to be separated once assembled.
4. Rotate the center of the fan cover
Unlatch the latch
5. Attach the vacuum tube assembly to the power head
(Fig. H) by locating the assembly as indicated by arrow,
then align the four tube lock tabs on the tube with the
four locking slots. Insert the tube into the housing and
4
twist clockwise to lock the tube into place and close the
interlock switch.
Fig. F
5
Ensure the vacuum is switched
CUT HAZARD. Ensure the tube
7 . (Fig. F)
9 counterclockwise.
18 and open the fan cover
6
English
6 and
9 .
7
5