Self Regeneration Mode - Hyundai i20 Owner's Manual

Maintenance

4. Self Regeneration Mode

LCD Type
If the warning message "Self
Regeneration" is stored in inspection
message tap, it is operable in LCD
warning message page.
WARNING
• Make sure the vehicle parked on
safety zone (to avoid the flammables
like grass and traffic accident)
• Check remained fuel above 1/5 of
full level fuel gauge to prevent fuel
overheat
• Open the hood to prevent engine
room overheat
• Self regeneration should be done
only when DPF indicator illuminates
If the warning message "Diesel filter
regeneration required, See owner's
manual." appears on the LCD display,
Self Regeneration is required
10-102
To initiate Self Regeneration
1. Engage parking brake and shift lever
at P state.
2. Turn on the engine
3. Warm up the engine and check engine
temperature gauge at the middle
position
4. Turn on the air conditioner and set the
blower to the maximum.
5. Turn on the high beam.
6. Operate the rear defog function.
7. Hold the OK button on the LCD
warning message page.
8. Turn off and turn on the engine again.
OSU2I089042 OSU2I089042
OSU2I089039 OSU2I089039