Instructions For Ground Attachement And Fixation To Wall; Computer Workstation - GARANT 92 Series User Manual

5.4

Instructions for ground attachement and fixation to wall

Depending on the configuration it may be necessary to anchor the cabinet
to the floor to prevent it tipping over accidentally. Anchoring it to the floor
DE
ensures that the tool cabinet is secure and stable.
If the cabinet is attached to the wall (wall-hung cabinet) please check the
load-bearing capability of the wall structure.
For certain types of wall construction, such as plasterboard and studding
walls, special wallplugs are necessary. These are not included in the
delivery. When drilling close to the edge of walls, please refer to the plug
manufacturer's datasheet for the minimum distances.
X
EN

6. Computer workstation

The computer workstation / Info-Point is suitable for the transport, storage
FR
and operation of computers, monitors and printers under industrial condi-
tions.
When using the computer workstation / Info-Point, note the following points:
X
X
X
IT
X
X
X
ES
X
38
For other types of substrates, seek professional advice.
CAUTION
Before drilling, make sure there are no pipes and cables buried
X
in the wall near where the anchor holes are planned.
Only original parts may be fitted to the computer workstation / Info-Point
or used as spare parts.
When installing items of equipment, please comply strictly with the
installation instructions and operating instructions for those items.
If computer workstations / Info Points are mounted on wheels, the wheel
brakes must be applied when the equipment is stationary.
If the ambient air is no dirtier than normal, the filters should be cleaned at
least once a week. If the ambient air is dirtier than this, the filters should
be cleaned every day. To do this, carefully lever off the cover using a slot-
head screwdriver, change the filter and refit the cover
(it closes with an audible click).
Modifications may be made only by qualified skilled personnel.
As a precaution to prevent accidents, when the cabinet is moved it must
be by pulling it (accident prevention regulations of the trade association
insurers).
Pull out the cable glands using suitable combination pliers, and deburr
the edges.