The Remote Control - Chord Hugo TT 2 Manual

Chord Electronics
Hugo TT 2 | Manual
_

The remote control

3.5
For convenience, a branded
infra-red remote control is
included with the device.
The remote will operate up to a
distance of 10 metres with clear
line-of-sight to the infra-red
receiver within Hugo TT 2, which
is located below the looking
glass.
For best operation, do not
operate the Hugo TT 2 within a
cabinet or place other materials/
Select USB
devices on top of the device.
Selecting optical input via Select optical
input (press and hold)
remote: A single press of the OPT
button will select the previously
Select Bluetooth
selected optical input. A longer
press of 3-seconds will switch to
the next optical input.
Increase volume
Cycle through
Cycle through
16 // 35
3.1 Getting to know Hugo TT 2 3.3 The top panel
& drivers 3.4 The rear panel
3.2 The front panel 3.5 The remote control
Select BNC
On/off
coax 1 input
Select BNC
input coax 2 input
Mute playback
input Increase volume
Cycle through
LED brightness
filter type
crossfeed
NOTE: Please only
insert AAA batteries
into the IR remote
control and observe the
correct orientation as
indicated within the remote
control. Failure to do so
could result in non-operation
or battery leakage.
Chord Electronics
Hugo TT 2 | Manual
_
Setting up 4.0
Hugo TT 2
4.1 Placement
4.2 Connecting Hugo TT 2 to equipment
& Hugo TT 2 power-on sequence
4.0
Setting up
Hugo TT 2
17 // 35