Siemens HR478GC.6B User Manual And Installation Instructions page 32

en Troubleshooting
Fault
Appliance is not heating, the
colon flashes in the display and a
appears.
Steam-assisted operation does
not start.
The appliance door cannot be
opened; lights up in the dis-
play.
The appliance door cannot be
opened; lights up in the dis-
play.
The time flashes in the display.
The time does not appear in the
display when the appliance is
switched off.
lights up in the display and no
settings can be made on the ap-
pliance.
flashes in the display and the
appliance will not start.
appears in the display.
- appears in the display.
A message with appears in the
display, e.g. - .
32
Cause and troubleshooting
Demo mode is activated.
1. Briefly disconnect the appliance from the power supply by switching the cir-
cuit breaker in the fuse box off and back on again.
Deactivate demo mode within five minutes by changing the basic setting
2.
⁠ ⁠ to .
→ "Basic settings", Page 21
The water tank is empty.
Fill the water tank.
▶
→ "Filling the water tank", Page 13
Descaling locks operations with steam-assisted cooking.
Run the descaling programme in full.
▶
→ "Descaling", Page 27
The steam system is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 34
The childproof lock locks the appliance door.
Use the button to deactivate the childproof lock.
▶
→ "Childproof lock", Page 20
The cleaning function locks the appliance door.
Allow the appliance to cool down until
▶
→ "Self-cleaning ", Page 26
There has been a power cut.
Reset the time.
▶
→ "Setting the time on the clock", Page 15
The basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 21
Childproof lock is activated.
Use the button to deactivate the childproof lock.
▶
→ "Childproof lock", Page 20
The cooking compartment is too hot for the selected operation.
Switch off the appliance and allow it to cool down.
1.
Restart the operation.
2.
The maximum cooking time has been reached. To prevent an unwanted per-
manent operation, the appliance automatically stops heating after several hours
if the settings are unchanged.
Switch off the appliance.
▶
You can configure new settings if required.
Tip: To prevent the appliance from switching off when you do not want it to,
e.g. for an extremely long preparation time, set a cooking time.
→ "Time-setting options", Page 14
There is too much water in the steam system. The water cannot be pumped
back into the water tank.
Empty the water tank and insert the empty water tank.
1.
→ "Emptying the water tank", Page 13
Reset the time.
2.
→ "Setting the time on the clock", Page 15
Switch the appliance off and on again.
3.
Run "Descaling interrupted" in full.
4.
→ "Descaling interrupted", Page 28
Electronics fault
Press the button.
1.
If required, reset the time.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. Quote the ex-
2.
act error message and the E no. of your appliance.
→ "Customer Service", Page 34
goes out in the display.