Transport - Gardenpro KCR26RC-BS User Manual

10) Hold the bag handles as shown in fig.27.
11) Overturn to empty the contents.
12) Lower the bag so it completely adheres to the
rear cover; if it does not, the safety switch will prevent
blade engagement.

CLEANING THE GRASS UNLOADING PIPE
CAUTION This operation must always be
performed with the engine switched off and
the ignition key removed.
Grass could block the pipe due to:
- bag full
- speed too high
- grass too high
Proceed as follows:
7) Operate the parking brake.
8) Disengage blade rotation.
9) Lift the blade deck as far as it will go.
10) Switch off the engine and remove the key.
11) Release the bag
12) Remove the accumulated grass from the rear part
of the pipe.
CUTTING SUGGESTIONS
CAUTION The machine is not suitable for
heavy-duty work and for mowing large quantities
of grass.
# When adjusting the cutting height and machine
OPERATING TIMES AND DAYS
The time of operation of the lawnmower could be
regulated by specific national or local lawns. Contact
the local authorities to find out.
speed, be careful not to overstress the machine.
# For problem-free use, the cutting height and the
movement speed must be adapted to the height of
the grass to be cut.
# In case of blockages and drops in engine speed,
engage a lower gear and further raise the blade deck.
# On particularly rough surfaces, work with greater
cutting height to prevent the blade knocking against
any surface irregularities, with resulting damage to
the blade and mechanical parts.
# Disengage the blade and move the deck to max
height position every time an obstacle or hump has to
be overcome.
# The blade must be in perfect condition and sharp,
so the cut is clean and without frays which could
cause the grass to turn yellow.
# The engine must be used at top speed, both to
ensure a clean cut of the grass and to achieve good
ejection of the cut grass through the unloading pipe.
# In case of drought, do not use very low cutting
levels so as not to damage the lawn.
# It is best to cut the grass when the lawn in dry.
# If the grass is very tall, performing two separate
cutting operations are preferred, on different days;
start with max height cutting with a low gear.
INSTRUCTION MANUAL

4.5 TRANSPORT

To change work areas, the machine can only cover
short distances.
CAUTION When cutting on slopes, reduce
speed of movement
conditions.
to ensure safety
63