Intended Use; Machine Assembly; Opening Packaging; Machine Parts - Gardenpro KCR26RC-BS User Manual

4) Reverse gear is engaged without having
disengaged blade rotation.
HAZARD Never tamper with the safety
switches and their power leads. In case of a
fault, do not use the machine, but contact a
qualified after-sales center.

1.7 INTENDED USE

This machine is designed to be used in the open air
only as a lawn mower for lawns and grassed area
in gardens and in compliance with the safety and
operating instructions indicated in this manual.
Any other use should be deemed "hazardous" and
shall invalidate the warranty and relieve the
manufacturer of all liability.
HAZARD This machine is not allowed to
circulate on public roads and is not
homologated to transport persons.

4. MACHINE ASSEMBLY

2.1 OPENING PACKAGING

The machine is shipped partially dismantled and
packaged in a carton with pallet to protect it during
transport. The packaged machine will appear as in fig.
1 and fig. 2.
CAUTION!! To prevent damaging the blade
deck and blade, move these to maximum
height during the downward movement of
the base platform. Be very careful when performing
this delicate unpacking operation.

2.2 MACHINE PARTS

The components of the machine to be assembled
appear as in fig. 3.
14) Machine body
INSTRUCTION MANUAL
15) Small cover plate
16) Steering seat casing
17) Steering seat
18) Seat
19) Bag frame
20) Steering wheel
21) Bag of screws
22) Steering wheel shaft extension
23) Upper cover of bag
24) Fabric grass bag
25) Bag overturning handle
26) Battery box
2.3 IDENTIFICATION OF MAIN
19) Steering wheel - steers the front wheels.
20) Decorating casing.
21) Brake/clutch pedal.
22) Front steering wheels.
23) Washing link.
24) Blade deck - the casing protecting and enclosing
the rotating cutter blade;
25) Blade deck and cutting height adjustment
up/down lever.
26) Engine throttle lever.
27) Grass bag - besides collecting the cut grass, this
is a safety element that prevents the launching of
grass and collected materials.
28) Grass bag handles.
29) Driving seat - operator drive and control position.
MACHINE PARTS AND
CONTROLS (fig.4)
57