After Using The Housing Underwater - Sealife SportDiver Instruction Manual

VI. After using the housing underwater
Follow these important steps after each underwater use:
1. Soak the sealed housing in fresh water for about 20 minutes. Push each button 20 times to flush out any
saltwater, sand or dirt trapped under the buttons.
2. Towel-dry the housing. Make sure that you and the waterproof housing are dry before opening the
waterproof door.
3. Release the internal vacuum pressure before opening the housing. Unscrew the vacuum check port cap
and use your fingertip to move the yellow rubber one-way valve sideways to release vacuum pressure.
4. Make sure water drops around the O-ring sealing areas do not drip into the housing. Use a clean dry towel
to dry any water drops that have entered the housing.
5. The leak alarm may activate (beep) when opening the waterproof door. Power Off the housing to turn off
the leak alarm.
6. Follow the other care and maintenance instructions on page 43.
27