Sealife SportDiver Instruction Manual page 22

7. Power on your iPhone and open the SportDiver app. The app will display "Waiting for Connection". The
iPhone with opened SportDiver app closest to the housing will automatically connect within about 1 minute.
Once connected, the blue Power/Bluetooth LED will stop blinking and turn solid blue, and the Bluetooth
icon in the lower right of the display will turn from white to blue. Once the housing has connected, the app
will display a pressure gauge. If so, proceed to the next step. If the phone does not automatically connect,
power Off the housing and repeat step 6. Make sure your phone is close to the housing and app is open.
Waiting for connection message
Note
•
Do not touch the gold water sensor located on the inside bottom right of the housing. That will cause the
Leak Alarm to activate and display a "Leak Detected" message. If that happens, power the housing Off
and repeat steps 6 through 8.
Once connected a pressure gauge is displayed
21