Scanning and Switching between anynet+ Devices
1. Press the toolS button.
Then press the enter
. Press the ▲ or ▼ button to select "Select Device", then press the enter
. Press the ▲ or ▼ button to select to a particular device and press the enter
It is switched to the selected device.
. If you cannot find a device you want, press the ▲ or ▼ button to select "Setup", then
press the enter
button.
. Press the ▲ or ▼ button to select "Searching Connections", then press the enter
button.
The message "Configuring Anynet+ connection..." is displayed. When searching devices
completes, the connected devices are listed in the Anynet+ menu.
➣
Switching to the selected devices may take up to 2 minutes. You cannot cancel the
operation during the switching operation.
➣
The time required to scan for devices is determined by the number of connected
devices.
➣
When the device scan is complete, the number of found devices is not displayed.
➣
Although the TV automatically scans devices when it is turned on using the PoWer
button, devices connected when the TV is on or under a specific circumstance are not
displayed in the device list. Therefore select "Searching Connections" menu to search
devices.
➣
If you have selected external input mode by pressing the SourCe button, you cannot
use the Anynet+ function. Make sure to switch to an Anynet+ device by using the
toolS button.
button to select "Anynet+(HDMI-CEC)".
button.
english -
tV
P
View tV
Select Device
button.
record
menu on Device
Device operation
receiver
:off
Setup
move
enter
return
Setup
anynet+ (hDmI-CeC)
auto turn off
Searching Connections
move
enter
:
on
:
Yes
return