LGB Genesis 2 49 Series Expert Instructions

LGB Genesis 2x49x - Expert Instructions
Smoke, Sound and MTS Installation
Hint: The installation shown here requires the removal of the loco body shell and disassembly of the sound module. However,
reinstalling the body shell can be difficult. Alternately, you can install all the components through the removable roof panel and press
an unmodified sound module into the tabs in the loco chassis. However, this alternate technique may be difficult for people with large
hands, and the sound module will not be as secure.
Attention! It is possible to plug the decoder cable into the loco circuit board backwards. (See Step 8.) The loco will run
reversed from normal, and the smoke unit will get full track voltage, which will quickly damage the smoke unit.
1. Remove the body shell and roof panel. Install the 65853
smoke unit in the roof panel. Plug the wire terminals onto pins
labeled "Smoke" on loco's main board.
November 9, 2006
2. Disassemble the 65003 sound module. (Hint: Gently press in
the tabs on the sides of the module to snap the case apart.) Drill
two holes in diagonal corners of the speaker side of the case
to match the speaker mounting posts, and attach the case side
with two screws (from 69002). (Be sure to reinstall the speaker
grille and speaker before attaching the case side.)
3. Move the cables attached to the weight. Attach the remaining
side of the module case to the weight (forward of the body
frame) using double-stick tape or Velcro (not included).
4. Attach the module circuit board to the case with double-stick
tape.
Attention! We strongly recommend authorized service
for your LGB product. Neither Ernst Paul Lehmann
Patentwerk nor LGB of America will provide support for "do-it-
yourself" service or any other unauthorized service. You assume
the risk for "do-it-yourself" service or any other unauthorized
service.