Moog MINITAUR v2.2 Quick Start Manual page 2

SHIFT PANEL FUNCTIONS QUICK REFERENCE GUIDE
The GLIDE switch on your Minitaur can act as a "shift" key, allowing quick access to a number of extended
functions directly from the panel.
MOD SOURCE SELECTION:
GLIDE + LFO RATE
VCO 2 BEAT FREQUENCY:
GLIDE + VCO 2 FREQ
FILTER EG DELAY TIME:
GLIDE + FILTER EG ATTACK
DRONE ON/OFF:
GLIDE + AMP SUSTAIN (Min to Max = ON)
GLIDE + AMP SUSTAIN (Max to Min = OFF)
DECAY/RELEASE MODES
Press and hold the RELEASE switch for 1 second to change modes. The RELEASE switch LED will blink one
time to indicate Mode 1, or two times to indicate Mode 2.
MODE 1: Decay and Release times are linked and the RELEASE switch enables or disables the Release
stage of the envelope.
MODE 2: Decay and Release times are independent. If RELEASE is lit, the DECAY/RELEASE knob is
editing Release time. If RELEASE is dark, the DECAY/RELEASE knob is editing Decay time.
HARD SYNC ON/OFF:
GLIDE + VCO 2 LEVEL
EXT. INPUT LEVEL:
GLIDE + VCO 1 LEVEL
FILTER EG HOLD TIME:
GLIDE + FILTER EG DECAY/RELEASE
TOP OCTAVE WRAP ON/OFF:
GLIDE + GLIDE RATE
VCO 2 MOD ONLY ON/OFF:
GLIDE + VCO LFO AMT
EG TRIGGER MODE:
GLIDE + AMP EG ATTACK
AMP EG HOLD TIME:
GLIDE + AMP EG DECAY/RELEASE
PANIC/ALL NOTES OFF:
GLIDE + AMP EG SUSTAIN TO ZERO.