1. Manuals
  2. Brands
  3. Bastl Instruments Manuals
  4. Synthesizer
  5. KNIT RIDER EXPANDER v1.0
  6. Assembly manual

Bastl Instruments KNIT RIDER EXPANDER v1.0 Assembly Manual

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

 
KNIT RIDER EXPANDER v1.0 ­ Assembly Guide 
 
 
INTRODUCTION 
 
This guide is for building Knit Rider Expander module from Bastl Instruments. It is good to have basic
 
   
 
soldering skills and to be able to identify electronic components before starting this kit. However if you
 
 
   
have never soldered before, check out this ​
 
 
 
solder to help you solder everything faster and better. 
 
The module consists of one board. All the parts comes in two bags separated for Bottom board and
 
 
   
Assembly parts. See Bill of Materials ( ​
 
  ​
h
ttp://www.instructables.com/id/How­to­solder/  
1
bastl­instruments.com 
 
 
 
 
 
   
 
 
 
 
 
t utorial first
 
 
 
 
B OM ​
)  for detailed list. 
 
 
 
 
 
 
. We even included some of the best quality
 
 
 
1
 
   
 
 
1 
last update: 29. 4. 2016 
 
     
   
 
 
 
 
 
   
 
 
 
 
 
 
 
   
 
 
 
 
 

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KNIT RIDER EXPANDER v1.0 and is the answer not in the manual?

Questions and answers

Related Manuals for Bastl Instruments KNIT RIDER EXPANDER v1.0

Summary of Contents for Bastl Instruments KNIT RIDER EXPANDER v1.0

  • Page 1     KNIT RIDER EXPANDER v1.0 ­ Assembly Guide  bastl­instruments.com        INTRODUCTION    This guide is for building Knit Rider Expander module from Bastl Instruments. It is good to have basic                            ...
  • Page 2     Before starting this kit, prepare the following tools:  ● Soldering iron (15­20W)  ● Multi­meter  ● Flush cutters  ● Wrench No. 8  ● Protective eyewear    We suggest that you work in a clean and a well lit and ventilated environment to avoid accidents or                ...
  • Page 3 Next place and solder the IC socket​ . Make sure that the ​ n otch is in the same direction as printed on                                      ...
  • Page 4 Place the ​ f ront panel on. Make sure that the components are properly aligned. Screw the panel with                                   washers ​ a nd ​ n uts (don't tighten them too much as you may damage the panel). Push the LEDs leads  ...

Table of Contents