Graco Lube Sentinel II Instructions Manual page 14

Step-By-Step Programming Instructions
Step-By-Step Programming Instructions
The following instructions are listed in order of appear-
ance. To bypass a selection, press the SLCT button until
the desired selection displays.
Configuration?Zone1
1. Press PRGM button to enter the programming
mode.
CONFIGURATION?ZONE1 displays.
2. With CONFIGURATION?ZONE1 displayed, press
the PRGM button again to enter the options for
Zone 1.
• Enable Zone: The first option will be to enable
the zone.
a. Press SLCT button to toggle between YES
and NO. If the zone is not to be enabled, no
further options will be asked for. A disabled
zone appears as dashes across the screen
and will not generate any faults. (F
b. Press PGRM again to advance to the next
programming option.
F . 12
IG
• Units of Measure: Choose one - ounce, pints,
gallons, liters, milliliters or counts.
a. Press the SLCT button to toggle between the
displayable units.
b. When choice displays on screen, push
PGRM button to advance to the next pro-
gramming option.
NOTE: Each zone can read out in different units.
14
• Port Total: The total quantity of lubricant vol-
ume provided to lubrication points.
This input is necessary for calibrating the Senti-
nel II for the lubricant volume required for one
cycle of the divider valve assembly.
To determine this number:
a. Locate the divider valve assembly that has
b. Add the output volume numbers stamped in
. 12).
IG
F . 13
IG
c. Double the sum quantity.
d. Subtract any individual output value(s) con-
the lube system cycle switch mounted on it.
the upper right corner of each of the assem-
bly's valve sections (F . 13) (i.e., the 10 from
IG
a 10T or 10S section. etc.).
nected to an output line that is not feeding a
lubrication point or another secondary feeder
assembly (i.e., a line returning oil to the reser-
voir, or any other destination that is not a
rotating/moving lubrication point).
This number is the Port Total.
313903B